Strummer Wheelset Spoke Size Calculator
STRUMMER PRODUCT TOOLS
Spoke Length Calculator
Calculate estimated spoke lengths for J-Bend and straight-pull Strummer or OXO hubs. Select a hub and rim; the calculator will automatically adjust the calculation.
Attention: The calculator allows combinations of hubs and rims that may not be compatible. Check the hole count, braking system, axle size, asymmetric rim installation direction, and product availability before purchasing or assembling.
INPUT DATA
Select Hub and Rim
mm
mm
Use 0 mm for a symmetric rim. For an asymmetric rim, enter the positive offset value specified by the rim manufacturer. Ensure the rim orientation during assembly matches the left- and right-side results.
CALCULATION RESULTS
—
—
Front Wheelset
—
| Lacing pattern | Left Disc Side* |
Right Non-Disc Side* |
|---|
Rear Wheelset
—
| Lacing pattern | Left Non-Drive Side |
Right Drive Side |
|---|
*The drive-side designation follows the orientation of a disc-brake hub. For rim-brake or symmetric hubs, still match the physical flange side during assembly. Recommendation markers indicate common configurations based on the number of spokes; they are not mandatory requirements for every hub and rim combination.
Important: the main figure shows the nominal size rounded to the nearest 1 mm. The geometric calculation result before rounding is displayed in smaller text to 2 decimal places. The wheelbuilder must still determine the final length based on the available spokes, nipple length, ERD tolerance, measurement method, and target spoke-end position. Verify with the actual components before placing a large order.
