Strummer Wheelset Spoke Size Calculator (Straightpull)
Kalkulator ini khusus untuk kombinasi wheel dengan hub straight-pull. This calculator is specifically for wheel combinations with straight-pull hubs. For the Strummer J-Bend hub, use the separate J-Bend calculator page.
Results are displayed to 2 decimal places.
Attention: The tool on this page allows you to select combinations
with a spoke hole count that matches the selected hub. The selected rim may also be unavailable
make sure the entered ERD and offset values are correct. Check stock again,
the number of holes, braking system, and specifications of each component before purchasing
or assembly.
mm
mm
Use an offset of 0 for a symmetrical rim. For an asymmetric rim, enter the positive offset value according to the rim specifications.
Number of spokes
—
Lacing pattern
—
CALCULATION RESULTS
—
Front Wheel
—Left
Disc Brake Side
—mm
Right
Non-Disc Side
—mm
Rear Wheel
—Left
Disc Brake Side / NDS
—mm
Right
Drive Side / DS
—mm
Important: results are displayed to 2 decimal places.
Wheelbuilder still needs to determine the final spoke length based on the available spoke options,
nipple length, ERD tolerance, measurement method, and the target position of the spoke end inside the nipple.
Verify before ordering spokes in large quantities.
